The Ideal Deluxe is an excellent, metal-framed utility pet door. The flap on this pet door is a flexible, vinyl flap with a magnetic strip across the bottom of the flap to aid in closure. The flap itself is easily replaced if it were to become damaged. The pet door also comes with a slide-in locking panel that allows you to secure the pet door when it is not in use.

Ideal Pet Deluxe Pet Door

TOOLS REQUIRE FOR INSTALLATION:

Scissors . Hammer and Awl (or Nail) . Drill and 3/8 Bit . sabre Saw . Phillips Screwdriver
1. Determine template placement - Using scissors, cut template along dotted lines as indicated.
Center template (width) in middle of door; tape in place. Position the top of the template 2" taller than
your pet's shoulder.
Important: Under no circumstances should the bottom edge of the rough opening be less than 3" from
the bottom edge of the wood door.

2. Outline pet door opening - With template taped in place, use a pencil to draw around the inside
edge of template onto door. Use a nail or awl to mark inside edge corner holes and outer hardware drill
holes.

3. Drilling holes - Drill four 3/8" diameter individual holes (the inside edge corner locations will serve as
a guide). Next: Drill the 3/8" diameter outer door hardware holes.

4. Cutting the opening - Begin with one of the inside edge corner holes. Next: Using a sabre saw,
carefully cut along the pencil line.
5. Assembly & Adjustment (See Diagram 1) -
Insert outer frame (A) (no flap) into opening from
exterior side. Make certain frame is flush with door
surface. No adjustment is necessary if frame does
not extend beyond interior opening. If part of the
outer frame extends into interior, remove "break-off"
levels on outer frame (B) as required. Use
pliers to break off a single level at a time starting at
top, bottom then sides. Start at corner and bend
metal inward toward center in 2" intervals.
Caulking is recommended under outer frame.
Place inner frame (C) (with flap) into opening from
inside of door, hold in place, insert binder posts (D)
through exterior frame, then install screws (E) and
tighten until snug. Do not over-tighten. If screw
extended past outer edge of post, remove screw,
cut-off accordingly, then re-insert.

Note: Uneven Surfaced Doors:
If your door has an uneven surface, after cutting the rough opening, build up the lowest area with
wood frame thick enough to make an even door surface. If both sides of your door are uneven,
repeat the process for the other side.

Installation In Walls And Other Types Of Doors

The pet door can be installed in walls, steel doors and storm doors, however, additional materials such as
wood framing, plaster, touch-up paint, longer frame screws and additional tools may be required.
Walls: Once an opening has been made in a wall it will be necessary to build a frame to cover the exposed area
between wall surfaces. Use wood screws to attach interior and exterior frame to wall surfaces. When cutting
through walls, extreme caution must be used so as not to cut any concealed electrical wires, gas lines or water
pipes.
Steel Doors: To create an opening in a steel door use a jigsaw with a hacksaw blade to cut the opening
starting at pre-drilled corner holes.
Storm Doors with 1/2" or less: Starting at any pre-drilled corner hole, use tin snips to cut out rough
opening. Break off levels 1 & 2 (B) as required (See Diagram 1).