The Ideal Window inserts are single pane glass, single flexible flap window pet doors.  It's unique feature is the greater adjustment range, when compared to other window inserts. Both ends of the insert are spring-loaded, allowing for approx 5 inches of play. This unit has more probability of fitting more than one window (as long as their widths fall within selected ranges), than other window units. The flexible vinyl flap pet opening is situated in the center of the unit.

Note: A slide-in locking panel is included, this locking panel slide in from the top.  If your window sash has wide frame, then it may be necessary to bring the window unit forward to slide in the locking panel.

This unit is only available in the white frame.

Sash Window Pet Door

Installation Instructions 

1. Raise your sash window pane. Hold Secure.
2. Foam Bumper Seal is included. Cut 2 pieces of bumper seal to the same length as the width of your window.  Peel off protective backing and attach foam along top and bottom edge of pet door.
3. Place the pet door assembly between the window sill and the open window.
4. Lower the window pane until it touches down onto the pet door assembly.
5. Turn the silver knobs counter-clockwise one turn to release the end spacers.
6. Pet door assembly should now fit the window snugly on both ends.
7. Turn silver knobs clockwise to lock ends in position.
8. Vinyl Draft Stopper extrusion is included. Cut to required length. Clean window surface and peel off protective backing.  Attach along top edge of the lower window. Make sure inside flexible edge touches glass.

 

***If knobs interfere with bottom sill, you may remove knobs as follows:

1. Take out 2 screws that hold adjustable end extrusions.
2. Push steel rods into long bottom extrusions about 1/8” below surface. Locking knob and pin will then pull out.
3. Re-assemble adjustable end extrusions.

 
Note: Leave top knobs in place to lock your pet door in position.