Note: Many customers prefer this insert to higher costing panels because they can easily put-in and take-out this panel very easily. Often the dual pane units are much heavier due to the glass. If the weather or temperatures become too severe, this unit can be removed and set off to the side with very little effort. Chances are your pet would not be going outside it the weather were extreme.
*Panel width is approximate
You know your pet best - double check the opening and rise selected to ensure best fit
Pet Opening 7"w x 11 1/4"h: Appropriate for larger cats, and small dogs (Shih Tzus, Bichons, Yorkies, Papillons)
Rise Options: This unit comes standard with a 4" high step over rise, an optional 2.5" custom rise is available.
Weatherstripping: Included foam bumper and vinyl draftstopper for gap between slider and fixed panel.
Adjustable height range 80 1/4" to 93 3/4": The top section floats on two tension rods. You simply compress the top and fit it in the track, then release the top. A thumb bolt on either side near the top secures the top section so the Patio Pet Door cannot be removed from the outside. This unit will have a custom extension piece based on the height you provide us. This custom piece will sleeve into the top of the main Patio Insert to provide you the proper height. Larger extension pieces may be more secure if you use a couple of screws to secure the extension piece in place - on the interior side of the panel. (Not included).
Push Pin Lock included: We strongly suggest chocking the door with a stick as this immobilizes your slider. We also have accessory sliding door locks that you may use.
Installation Location: Most customers install next to the sliding door. Can be mounted on the fixed side of the slider. Some fixed windows are molded in and for those, this will not work. Others, have stoppers either in the bottom or top track that keep the fixed side stationary. If you remove the stoppers, you can pull out the fixed side far enough to accept the patio insert.
Security Panel: Includes a slide in locking panel to use when you want to "lock off" the pet opening.
Ideal Pet Patio Pet Door Installation Instructions
the panel against door jamb and make sure that top is fully extended, not tilted
to one side.
knobs by turning clockwise to lock the panel in place.To permanently install, you may screw through the aluminum fins that protrude
on the existing frame of your door. Drill through the fins into the panel.
Install two screws in the top and two in the side by the bottom of the panel. Do
not put any screws into the frame by the glass as breakage may occur.Optional permanent placement for fixed panel sliding door. Remove screws that
hold fixed glass panel in place and slide over. Insert the panel and re-fasten
fixed glass panel.Installing Security Lock (Optional)
(Placement Options-see above)With sliding door in closed position, place lock in desired location and bolt
in the retraced position, pointed toward the sliding glass door or stationary
window rail. Leave approximately 1/8” clearance between bolt tip and aluminum
rail.Holding lock firmly in place, mark screw holes and center of bolt in rail of
sliding door or stationary window.Drill two 5/32” holes for mounting screws and a 3/8” hole for locking bolt.
Caution: Do not drill into glass.With sliding door in the closed position (with patio door installed), mark
position for second set of holes.Repeat above instructions Caution: Do not drill into glass.
Weather Stripping PlacementThere are two pieces of weather stripping included in this package. A thin, wide
draft-stopper with an adhesive strip that attaches to the back side of
the sliding door that extends to the glass of the fixed window.The
other thin piece of weather stripping is the foam bumper, also with an
adhesive backing, it attaches to the panel to provide a better seal when the
sliding door closes against the panel.